Magnatech 72 x 72 side feed mill with HPU for lift cylinders

Steel Belt (pan type) infeed conveyor 20’ load section 40’ incline section

Side Reject Door

Dual Feed Rolls

Bearing oil cooling pump

Spider Rotor

250lbs hammers

Pin Puller (portable)

1250 Hp Reliance shredder motor with soft start and control panel 4160 V

Under Mill Oscillator

Transfer conveyor 20’ x 4’

New sets of grates, hammers, wear parts and much more

Shredder Maintenance over the last four years

• Infeed Conveyor $53,838.
• DFR Chute $4,339.
• DFR Hydraulic Lift Cylinder $7,249.
• DFR Drive Unit $3,239.
• Reject Door / Mill Tilt HPU $1,934.
• Shredder & Rotor Maintenance $39,594.
• Electric Drive Motor $176,917.
• UMO Conveyor $11,012.
• KVL Alum Shredder $26,587.

Shredder was being used for irony aluminum and is in very good condition and very well maintained.

Recently Disconnected

An inspection report is available.