Primary Components

• (1) Infeed conveyor to Shred Tech AZ-80 primary shredder
• (1) Shred Tech AZ-80 dual shaft shredder with 2” knives
• (2) 40Hp motors 240/480 volt 3 phase 60 Cycle & PLC Control Panel
• (1) Vibratory Discharge conveyor under AZ-80
• (1) Take away conveyor / picking conveyor from vibratory conveyor
• to infeed conveyor to Shred Tech
• (1) Lift conveyor to Shred Tech STQ-100E shredder
• (1) Shred Tech STQ-100E Quad Shaft secondary shredder 1” knives
•      Two Screen sizes for the Shred Tech above
• (2) 75 Hp motors 240/480 volt 3 phase 60 cycle & PLC Control Panel
• (1) Lift conveyor from under Shred Tech shredder to Vibratory feed conveyor
• (1) Vibratory feed conveyor for Eriez ECS
• (1) Dings Overbelt Magnet above vibratory conveyor
•       New Spare belt for Dings overbelt magnet
• (1) ERIEZ Eddy Current Separator ( belt replacement suggested)
• (1) Long throw take away conveyor
• (1) Short throw take away conveyor

All motors, controls, stands, ladders, walk ways etc. are included
All components are in good condition and were removed in running condition
The Dings overbelt magnet needs a new belt which is included

The Eriez ECS will shortly need a new belt

All other conveyor belts are in good condition
The system has been disassembled and stored outside except for the electrical control panels which have been housed inside.

Very nice, complete system, for shredding and separating electronic components