1980 Williams 560 Series Hammermill Shredder

• Size 52x60
• Serial Number 17532
• Z-pan infeed conveyor
• Mill base
• Mill mid-section with lift cylinders
• HPU for hydraulic cylinders
• Spider rotors with bearings and housings
• Pin puller
• 1,000 HP shredder motor rebuilt, 60Hz, 3 phz, 4140 voltz
• Motor starter & control panel
• Motor coupler
• NO UMO
• 60" rare earth drum magnet... NO magnet stand
• 185lb hammer set
• 130lb hammer set
• New grate set
• Used grate set
• NEW spider rotor & shaft (unassembled)
• New hammer pins
• New liners and many spare parts
• (2) extra bearing housings
• Hinge pins

This shredder is in very good condition, it has a 1000Hp motor that was rebuilt and never put in service.

Tons of spare parts, liners, hammers grates etc.

Seller will install on buyer's foundation for an additional $25,000. Installation cost is labor only and does not include materials or crane rental.

Sold As Is Where Is.